LN-RVXVan's Aircraft RV-10 · build log
What is Firstflight? Log in
Planning
Building
Final inspection
Flight test (Phase 1)
In service

6-2 steps 6, 7 and 8, 6-3 steps 1 and 2

5 November 2026 Empennage › Vertical stabilizer 1.3 h

6-2 step 6: The plans says to use a 3/16" drill to match drill the holes, and to later use a #12 drill to final size them. Closest drill bits I have is 4.5mm and 5mm, I opted for the 5mm since its still smaller than the final size. 

Step 8: Says to machine countersink four #19 holes. My countersink CC40 fits #40 holes, CC30 fits #30 holes so I started looking for the CC19 countersink. Searched far and wide, but did not have any countersink marked CC19. Was it missing from the toolkit? Sat down to read the packing list and looked up all the items on Cleaveland Tools webshop. Apparantly, CC10 fits #19. Again, Freedom Units is causing me headaches. I do feel that the microstops for the countersink must be adjusted between holes of the same size, maybe I put to much pressure on it - I don't know. Doing it very carefully to not over-countersink the material.

6-3 step 1: Says to deburr the edges of all remaining parts to prevent scratching during fitting. I couldnt feel any burr on the remaining parts - and I'm going to prime the parts anyways, so I went straight to fitting. Rounded the corners first as directed, not sure if I did this correctly, will do some more research on this particular topic before I proceed to attach the skin. 

Step 2: Clecoed the skeleton together, finally looks like a  real airplane part. Next step is to final drill all the holes common to the parts and then start fitting the skin. Before I can start dimpling the skin I need to build a table for my dimpler (CARD2 from Clemson Aeronautics), so I will probably get started on that before further work on the vstab. 

Starting to look like something that belongs to an airplane!

 

Comments

Write a new comment

A quick spam check runs in your browser – no puzzles, nothing sent to others.

← More from Vertical stabilizer