Build log
14 entries
6-3 steps 1-5
Step 2 says "Final-Drill all the holes common to the parts in the skeleton using a #30 size drill". I almost made a mistake here, by actually final drilling all the common holes as per the instructions. There are 2 hole…
Inspector visit
Visit from the EAA designated inspector for this project. Opted to hold off on any major and invasive modifications to the material before he had the chance to inspect my work so far. The spar caps discussed in a previou…
6-2 steps 6, 7 and 8, 6-3 steps 1 and 2
6-2 step 6: The plans says to use a 3/16" drill to match drill the holes, and to later use a #12 drill to final size them. Closest drill bits I have is 4.5mm and 5mm, I opted for the 5mm since its still smaller than the…
6-2 steps 2, 3, 4, 5 and 6
Last session ended because I did not have a 1/8" drill bit available. Posted a question on Vans Airforce, and got a tip to use a 3.1 mm drill bit instead. Closest I could find was a 3.2mm, but this is still smaller than…
6-2 step 2: Stuck already
I managed to get stuck at literally the first page of the instructions, step 2. It says Starting from the bottom of the spar, match-drill about every fourth hole of the rear spar web into the spar caps using a 1/8" dril…
First real work at actual airplane parts
Started by locating all the parts listed on the front page for the vstab. Surprisingly few parts. Storing items as they were shipped and using the inventory to look at which subkit the parts are in helps finding the righ…
Finished sheet metal basics project
Stopped working on this earlier because I messed up badly. But luckily I messed up a training project and not the real thing. In short, I was going to match drill the two sheets but I didn't check where the holes would l…
Just time entry
Started on the sheet metal basics assembly
Setting up my tools and started on the sheet metal basics project. With no experience whatsoever working with sheet metal it's a nice project to get familiar with how the metal acts when drilled in. First learning point:…
Finalized unboxing
Removed the last skins from the crate and stored them in the garage.