Rudder
Complete ✔ Approved · Section 7 · 7 entries · 23 h
+ Add a link
For example wiki articles, forum threads or suppliers' pages about this section.
Rudder done
Blind riveted the leading edge and installed the rod ends. Rudder complete.
Leading edge rolled
Rolled the leading edges with a broom handle and duct tape. Took three tries on the top part, but it closes nicely now.
Trailing edge riveted
Riveted the trailing edge in three passes, a little at a time. String test shows it is straight within 1 mm over the whole length.
Trailing edge wedge
Glued the trailing edge wedge with ProSeal and clamped it between two straight angles to cure for a week.
Stiffeners riveted to the skins
Back-riveted the stiffeners to the skins on a steel plate. Back-riveting gives beautiful flat heads.
Rudder skeleton
Assembled the rudder spar, ribs and horn brace. Match-drilled the skins to the skeleton.
Rudder stiffeners
Cut and deburred the rudder stiffeners from the angle stock. Back-drilled them to the skins.
Inspector review
✔ ApprovedApproved by Demo Inspector on 15 November 2025, based on the online log.
Trailing edge is straight per the photos and the string test. Approved from the log.
No comments or remarks yet.
Inspector task Approving is the inspector's task. As the owner you can approve too; the inspectors are notified.
Log entry inspections
Plans
No plans uploaded for this section yet.
Comments