Vertical stabilizer
Complete ✔ Approved · Section 6 · 6 entries · 21.5 h
+ Add a link
For example wiki articles, forum threads or suppliers' pages about this section.
VS riveted
Riveted the skeleton, then the skin. My wife bucked for the hard-to-reach ones. Only two rivets drilled out. The VS is done!
Primer
Scuffed and cleaned all the internal parts and primed them with rattle-can primer. Let it cure overnight.
Deburring and dimpling
Deburred every hole and dimpled the skin with the C-frame. Machine countersunk the spar flange where the plans call for it.
VS skin match-drilled
Clecoed the skin to the skeleton and match-drilled all holes to final size. Took it apart again for deburring and dimpling.
VS ribs fluted and fitted
Fluted the ribs until the holes lined up with the spar flanges. Clecoed the skeleton together and it sits square on the bench.
VS spars
Deburred the front and rear spars and the spar doublers. Match-drilled the rear spar doubler to the spar per 6-2.
Inspector review
✔ ApprovedApproved by Demo Inspector on 11 October 2025, based on an on-site visit.
Visited the workshop. Rivets checked with the gauge, edge distances good, nice clean primer job. Approved.
No comments or remarks yet.
Inspector task Approving is the inspector's task. As the owner you can approve too; the inspectors are notified.
Log entry inspections
-
Nice result. Remember to keep the bottom rib holes open for the attach step.
Plans
No plans uploaded for this section yet.
Comments