Horizontal stabilizer
Complete ✔ Approved · Section 8 · 7 entries · 27.5 h
+ Add a link
For example wiki articles, forum threads or suppliers' pages about this section.
HS done
Final rivets on the rear spar. The HS is complete and on the shelf next to the VS.
HS skins riveted
Riveted the skins to the skeleton. The rear spar goes on last; used the long yoke squeezer where I could.
Front spar riveted
Riveted the front spar assembly. Asked Kari to have a look at the HS-1004 rivet line before I close it.
Deburr, dimple, prime
A long session of deburring and dimpling, then primer on all the inside parts.
Skins on the skeleton
Clecoed both skins on and match-drilled everything. Checked the twist on the table: within 1 mm tip to tip.
HS ribs
Fluted and fitted the nose ribs and the main ribs. Lots of parts on this one.
HS spars
Started on the horizontal stabilizer. Deburred and match-drilled the front spar and the reinforcement angles.
Inspector review
✔ ApprovedApproved by Demo Inspector on 28 December 2025, based on an on-site visit.
On-site visit before and after riveting the skins. Remark on the HS-1004 rivet line resolved. Approved.
-
HS-1004: the rivets at the outboard end of the front spar are close to minimum edge distance. Please measure and note it in the log before you close the skins.
Inspector task Approving is the inspector's task. As the owner you can approve too; the inspectors are notified.
Log entry inspections
Plans
No plans uploaded for this section yet.
Comments