Empennage
43 entries
Trailing edge riveted
Riveted the trailing edge in three passes, a little at a time. String test shows it is straight within 1 mm over the whole length.
Trailing edge wedge
Glued the trailing edge wedge with ProSeal and clamped it between two straight angles to cure for a week.
Stiffeners riveted to the skins
Back-riveted the stiffeners to the skins on a steel plate. Back-riveting gives beautiful flat heads.
Rudder skeleton
Assembled the rudder spar, ribs and horn brace. Match-drilled the skins to the skeleton.
Rudder stiffeners
Cut and deburred the rudder stiffeners from the angle stock. Back-drilled them to the skins.
VS riveted
Riveted the skeleton, then the skin. My wife bucked for the hard-to-reach ones. Only two rivets drilled out. The VS is done!
Primer
Scuffed and cleaned all the internal parts and primed them with rattle-can primer. Let it cure overnight.
Deburring and dimpling
Deburred every hole and dimpled the skin with the C-frame. Machine countersunk the spar flange where the plans call for it.
VS skin match-drilled
Clecoed the skin to the skeleton and match-drilled all holes to final size. Took it apart again for deburring and dimpling.
VS ribs fluted and fitted
Fluted the ribs until the holes lined up with the spar flanges. Clecoed the skeleton together and it sits square on the bench.