Demo You are looking at LN-DMO as its owner sees it – build log, costs, maintenance, notifications and settings. Look around freely; nothing can be changed. Start your own
LN-DMOVan's Aircraft RV-10 · build log
Tasks 2 Inspections 11
Settings What is Firstflight? Log in
Planning
Building
Final inspection
Flight test (Phase 1)
In service

Build log

74 entries

+ New entry
NO PHOTO
2025-11-22 Empennage › Horizontal stabilizer

Skins on the skeleton

Clecoed both skins on and match-drilled everything. Checked the twist on the table: within 1 mm tip to tip.

4.5 h ✔ Inspected
NO PHOTO
2025-11-16 Empennage › Horizontal stabilizer

HS ribs

Fluted and fitted the nose ribs and the main ribs. Lots of parts on this one.

4 h ✔ Inspected
NO PHOTO
2025-11-12 Empennage › Horizontal stabilizer

HS spars

Started on the horizontal stabilizer. Deburred and match-drilled the front spar and the reinforcement angles.

3.5 h ✔ Inspected
NO PHOTO
2025-11-08 Empennage › Rudder

Rudder done

Blind riveted the leading edge and installed the rod ends. Rudder complete.

2.5 h ✔ Inspected
NO PHOTO
2025-11-05 Empennage › Rudder

Leading edge rolled

Rolled the leading edges with a broom handle and duct tape. Took three tries on the top part, but it closes nicely now.

3 h ✔ Inspected
NO PHOTO
2025-11-01 Empennage › Rudder

Trailing edge riveted

Riveted the trailing edge in three passes, a little at a time. String test shows it is straight within 1 mm over the whole length.

4 h ✔ Inspected
NO PHOTO
2025-10-22 Empennage › Rudder

Trailing edge wedge

Glued the trailing edge wedge with ProSeal and clamped it between two straight angles to cure for a week.

3 h ✔ Inspected
NO PHOTO
2025-10-18 Empennage › Rudder

Stiffeners riveted to the skins

Back-riveted the stiffeners to the skins on a steel plate. Back-riveting gives beautiful flat heads.

3.5 h ✔ Inspected
NO PHOTO
2025-10-12 Empennage › Rudder

Rudder skeleton

Assembled the rudder spar, ribs and horn brace. Match-drilled the skins to the skeleton.

4 h ✔ Inspected
NO PHOTO
2025-10-08 Empennage › Rudder

Rudder stiffeners

Cut and deburred the rudder stiffeners from the angle stock. Back-drilled them to the skins.

3 h ✔ Inspected