Build log
74 entries
VS riveted
Riveted the skeleton, then the skin. My wife bucked for the hard-to-reach ones. Only two rivets drilled out. The VS is done!
Primer
Scuffed and cleaned all the internal parts and primed them with rattle-can primer. Let it cure overnight.
Deburring and dimpling
Deburred every hole and dimpled the skin with the C-frame. Machine countersunk the spar flange where the plans call for it.
VS skin match-drilled
Clecoed the skin to the skeleton and match-drilled all holes to final size. Took it apart again for deburring and dimpling.
VS ribs fluted and fitted
Fluted the ribs until the holes lined up with the spar flanges. Clecoed the skeleton together and it sits square on the bench.
VS spars
Deburred the front and rear spars and the spar doublers. Match-drilled the rear spar doubler to the spar per 6-2.
Inventory done
Inventory complete. Two bags of AN470AD4-6 rivets were short, Van's will send them with the wing kit. Everything else accounted for and stored on shelves by section.
Empennage kit arrived
The crate arrived on a truck this morning. No visible damage. Opened it and started the inventory against the packing list.
Practice kit done
Finished the practice kit. Drilled out a few bad rivets on purpose to learn how. Feeling ready for the real parts.
Practice kit, part 1
Started on the practice kit. Drilling, deburring and dimpling went fine. The squeezer is easy; the rivet gun takes some practice to keep straight.